You can see clearly now
SPIDER+ is the innovative proposal of PERFORMANCE iN LIGHTING on projection light thanks to the new options of exclusive drivers settable at two levels. This technological system, today unique in the sector, allows having in a single product the possibility of adjusting the wattage on-site with a single "click" without opening the luminaire and allowing the light to adapt also to the needs of a later moment. All models in this series are IP67 rated, pre-wired, with IP68 waterproof fast-connector.
Series suitable for LED retrofit it may save up to 80% of the electricity bill besides less maintenance, with the same light emitted and in some cases with an even better visual comfort.
LED floodlight for indoor and outdoor, comprising:
Construction
- Die-cast aluminium housing, polyester powder coat finish ISO 9227/12944 - ISO 9223 (C5)
- Extra pure polished aluminium reflector
- Anti-ageing custom moulded silicone sealing gasket(s)
- Extra-clear, toughened, flat glass diffuser, silk-screened on the inside
- Glazing diffuser permanently sealed to the housing trough high-temperature resistant silicone
- Stainless steel locking hardware
Electrical
- Built-in driver
Installation
- The luminous flux data shown refer to the maximum power operating level
Listings
- CE
- EAC
- RCM
Warranty
- 5-year limited warranty. Complete warranty terms located at www.performanceinlighting.com
- Registered trademark ®
- Registered design ®
Luminaire designed to operate with two predetermined power levels that can be selected by the user with the external button.
Complete with magnetic level to be placed on the bracket at the time of mounting.
Cataphoretic process polyester powder-coated steel bracket with simplified mounting system.
Electrical connection through an IP68 quick external socket-plug connector that makes it possible to connect it to the network without opening the lighting element, made of techno-polymer, 3 poles x 1.5/2.5 mm², for wires ø 8 - ø 12 mm
Extra-clear flat tempered glass diffuser internally screen-printed.
Complete with 1 m factory pre-wired cable H05RN-F 3G1 mm².
Waterproof cable gland M16x1.5 for cables Ø 5- Ø 10 mm.
SPIDER+ 10 KIT models are equipped with a technopolymer ground spike and 3 metres cable H05RN-F 3G1 mm².
Driver On Board 220-240V 50/60Hz LED module protected against surges up to 500 V.
The DLS+DETEK versions are supplied with an electronic device complete with High Frequency sensor and a daylight sensor (DLS). This is programmed to switch the device on automatically when natural light is low, ensuring constant secure lighting at 30% of the luminous flow and reaching 100% of the flow when any presence is detected.
Die-cast aluminium pole clamp with polyester powder coat finish ISO 9227/19244 - ISO 9233 (C5) , for Ø 60 mm poles.
Pole clamp for Ø 76 mm poles is available as accessory.
IP66-rated, PA66 polyamide, socket-plug fast connector, complete with factory pre-wired cable for mains connection without opening the luminaire, for cables Ø 6.5 - Ø 10 mm.
Luminaire designed to operate with two predetermined power levels that can be selected by the user acting on the specific cable in the fast connector.
